Inspect a Forklift
There are more than 10,000 workplace injuries related to forklifts happen each year, according to HRSDC and OSHA reports. Many of these accidents are caused by operator error. Lack of appropriate equipment maintenance and inspection results in many others. Forklift maintenance and operation is not only the cause of personal injuries, but also of property damage. Forklifts could damage overhead pipes, sprinklers and building structures, and other equipment when utilized improperly. The following daily inspections should be done so as to lessen the likelihood of forklift mishaps.
Before inspecting different fluid levels turn off the engine. Inspect these fluids: hydraulic oil, fuel, engine oil, coolant and brake fluid. The tires also need to be inspected for signs of wear and tear. Check the tire air pressure. Check the condition of the forks. The load backrest must be attached tightly. Do a visual inspection of the top-clip retaining heel and pin. Then carry out an inspection of the hydraulic hoses, mast chains, cables and stops. Ensure that the finger and overhead guards are attached securely.
LP forklifts have propane tanks that have to be inspected for signs of rust, corrosion or damage. Test the battery's electrolyte levels and charge. All belts should be inspected for wear. Check to make certain the owner's handbook is stored on-board the forklift inside a storage compartment. Check the seat belt to make certain the latches are secure. Check the hood latch to make certain that it is functioning as it should.
Start the forklift and listen to the engine noise to make certain there are no unusual sounds. If there are, investigate promptly. Check the steering controls and the accelerator. The parking break and the service break should be correctly functioning.
The tilt control and drive control should be inspected to ensure proper functioning in both reverse and forward. Test the functioning of the lowering control and hoist, and the attachment control. Test the horn and lights. Then check the heater, defroster and wipers to make certain they are working well. Check each and every gauge to ascertain that it is reading within functional limits.