Most of the time, businesses will spend lots of money to purchase their forklifts. It is essential, therefore to take proper care of your equipment to protect your investment into the long run. It is really a great idea to know the procedures that are undertaken in taking care of and maintaining this machinery.
By starting up the forklift and listening carefully how it runs is one of the best ways to tell how good the engine is working. For instance, if there are any misses or knocks, the machinery is defective and this should raise some concerns. Additionally listen closely for any squealing sounds that come from the belts since these sounds would provide you with a lot of information.
When carrying out maintenance, some of the main components you will need to pay attention to comprise the horn, safety warning devices, the overhead guard, the lights and the gauges. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also essential to check the wiring.
After the above parts have been inspected carefully, proceed to the battery compartment in order to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell should be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter need to be replaced regularly. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be done. If there is a grease fitting on the axle make sure to apply some grease. Inspect the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Next, check every other part of the equipment like the wheels. If any kind of fault or problem is detected, be certain to address it immediately in order to make sure the machinery is working at its safest and optimum levels.